CCNA 200-125

Which two statements are true for SSH? (Select two.)

What is the binary pattern of IPv6 unique local address?

Which feature uses a random time to resend a frame?

Which two statements about the spanning-tree bridge ID are true? (Choose two.)

What are the two benefits of DHCP snooping? (Choose two.)

Which type does a port become when it receives the best BPDU on a bridge?

Which command can you enter to verify connectivity using echo request and echo reply?

Which purpose of the network command in OSPF configuration mode is true?

How many bits represent Network ID in IPv6 address?

After you configure a GRE tunnel between two networks, the tunnel comes up normally, but workstations on each side of the tunnel cannot communicate. Which reason for the problem is most likely true?

Which type of EIGRP route entry describes a feasible successor?

Which of the following encrypts the traffic on a leased line?

Which three checks must you perform when troubleshooting EIGRPv6 adjacencies? (Choose three.)

Which two statements about Ethernet standards are true? (Choose two.)

Which two protocols can detect Native VLAN mismatch errors? (Choose two.)

What does split horizon prevent?

Two routers Atlanta and Brevard are connected via their serial interfaces as illustrated, but they are unable to communicate. The Atlanta router is known to have the correct configuration. Given the partial configurations, identify the fault on the Brevard router, that is causing the lack of connectivity.

What are three characteristics of the OSPF routing protocol? (Select three)

What command can you enter to assign an interface to the default VLAN?

Which WAN topology provides a direct connection from each site to all other sites on the network?

Which WAN technology uses labels to make decisions about data forwarding?

What is the default encapsulation type for Cisco WAN serial interfaces?

Which protocol verifies connectivity between two switches that are configured with IP addresses in the same network?

Which of the below can be used to identify/trace traffic flow between the network?

Which statement describes the effect of the overload keyword in the ip nat inside source list 90 interface ethernet 0/0 overload command?

If three devices are plugged into one port on a switch and two devices are plugged into a different port, how many collision domains are on the switch?

How many primary IPv4 addresses can be assigned to a router interface?

What are types of IPv6 static routes? (Choose three.)

View the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?

Which Ethernet interface command is present when you boot a new Cisco router for the first time?

In which byte of an IP packet the traffic can be marked?

Which WAN topology is most appropriate for a centrally located server farm with several satellite branches?

Which two circumstances can cause collision domain issues on VLAN domain? (Choose two.)

Which statement describes the effect of the copy run start command on a router in enable mode?

Which three options are switchport configurations that can always avoid duplex mismatch error between the switches? (Choose three.)

Which value can you modify to configure a specific interface as the preferred forwarding interface?

Under normal operations, Cisco recommends that you configure switch ports on which VLAN?

Which statement about 6to4 tunneling is true?

What are two benefits of private IPv4 addresses? (Choose two.)

What routing protocol uses first-hand information?