CCNA 200-125
CCNA 200-125
CCNA 200-125
Set of flashcards Details
| Flashcards | 478 |
|---|---|
| Students | 26 |
| Language | English |
| Category | Computer Science |
| Level | Other |
| Created / Updated | 20.02.2017 / 03.10.2024 |
| Weblink |
https://card2brain.ch/box/20170220_ccna_200125
|
| Embed |
<iframe src="https://card2brain.ch/box/20170220_ccna_200125/embed" width="780" height="150" scrolling="no" frameborder="0"></iframe>
|
Which feature can you use to restrict SNMP queries to specific OID tree?
Which three options are types of Layer 2 network attack? (Choose three.)
Refer to the exhibit. Switch port FastEthernet 0/24 on ALSwitch1 will be used to create an IEEE 802.1 Qcompliant
trunk to another switch. What is the reason the trunk does not form, even though the proper cabling has been attached?
Which protocol provides a method of sharing VLAN configuration information between switches?
Refer to the exhibit. Which statement describes the effect of this configuration?
Which command is used to show the interface status of a router?
Which three statements are typical characteristics of VLAN arrangements? (Select three)
Drag-n-drop. Drag the cable type on the left to the purpose for which it is best suited on the right. (Not all options are used.)
Which two actions must you take to configure a PAgP EtherChannel between two switches, S1 and S2? (Choose two.)
What is the industry standard protocol for negotiating EtherChannel?
View the exhibit. A technician has configured the FastEthernet 0/1 interface on SW1 as an access link in VLAN 1. Based on the output from the show vlan brief command issued on SW2, what will be the result of making this change on SW1?
Which statement is a Cisco Best Practice for switch port security?
How many addresses will be available for dynamic NAT translation when a router is configured with the following commands?
Two features of the extended ping command? (Choose two.)
What is true about Ethernet? (Choose Two.)
Which entity assigns IPv6 addresses to end users?
Which two statements describe the IP address 10.16.3.65/23? (Select two)
Which command can you use to manually assign a static IPV6 address to a router interface?
Which statements are true regarding ICMP packets? (Select two)
Which device allows users to connect to the network using a single or double radio?
What is the correct routing match to reach 172.16.1.5/32?
Which destination IP address can a host use to send one message to multiple devices across different subnets?
Which two are features of IPv6?(Choose two)
How many bits are contained in each field of an IPv6 address?
View the Exhibit. All hosts have connectivity with one another. Which statements describe the addressing scheme that is in use in the network? (Choose three)
Which two features can dynamically assign IPv6 addresses? (Choose two.)
A new subnet with 60 hosts has been added to the network. Which subnet address should this network use to provide enough usable addresses while wasting the fewest addresses?
View the exhibit. All of the routers in the network are configured with the ip subnetzero command. Which network addresses should be used for Link A and Network A? (Select two)
Which two statements about wireless LAN controllers are true? (Choose two.)
The network administrator is asked to configure 113 point-to-point links. Which IP addressing scheme best defines the address range and subnet mask that meet the requirement and waste the fewest subnet and host addresses?
-
- 1 / 478
-
