CCNA 200-125

Which password type is encrypted?

Which command displays the number of times that an individual router translated an inside address to an outside address?

Which device types are used over serial links? (Choose two)

A security administrator wants to profile endpoints and gain visibility into attempted authentications. Which 802.1x mode allows these actions?

The command ip route 192.168.100.160 255.255.255.224 192.168.10.2 was issued on a router. No routing protocols or other static routes are configured on the router. Which statement is true about this command?

Which value can you modify to configure a specific interface as the preferred forwarding interface?

Which feature facilitates the tagging of frames on a specific VLAN?

Which two options are primary responsibilities of the APIC-EM controller? (Choose two.)

If you configure syslog messages without specifying the logging trap level, which log messages will the router send?

Which function allows EIGRP peers to receive notice of impending topology changes?

What should you do when the router password is forgotten?

What command is used to configure a switch as authoritative NTP server?

Which value is used in HSRP election process?

Which feature is configured by setting a variance that is at least 2 times the best metric?

You are configuring dynamic NAT on your Cisco IOS router. Which command is used to verify the interfaces that are being used as the outside interface and the inside interface?

Which three options are benefits of using TACACS+ on a device? (Choose three)

Which statement about QoS default behavior is true?

You have configured the host computers on a campus LAN to receive their DHCP addresses from the local router to be able to browse their corporate site. Which statement about the network environment is true?

Which two statements about proxy ARP are true? (Choose two)

Which set of commands is recommended to prevent the use of a hub in the access layer?

How does a router handle an incoming packet whose destination network is missing from the Routing table?

Which two statements about using leased lines for your WAN infrastructure are true? (Choose two.)

Which command is used to build DHCP pool?

Which three options are types of slow VLAN connectivity? (Choose three.)

Which set of conditions comprises a successful ping attempt between two connected routers configured with IP addresses on the same subnet?

What are OSPFs default hello and dead timers? (Choose two.)

What is the status of port-channel if LACP is misconfigured?

Which two options will help to solve the problem of a network that is suffering a broadcast storm? (Choose two)

Which of the following privilege level is the most secure?

Which statement about unique local IPv6 addresses is true?

View the exhibit. Given this output for SW3, what should the network administrator's next action be?

Which two statements about syslog logging are true? (Choose two.)

Which configuration enables OSPF for network 192.168.1.0/24?

At which layer of the OSI model is RSTP used to prevent loops?

Which of the following are benefits of VLANs? (Choose three.)

Which statement about VLAN configuration is true?

Which of the following port state is not included in STP active topology?

If you are configuring syslog messages specifying logging trap warning, which log messages will the router send?

View the exhibit. What can be determined about the interfaces of the Main router from the output shown?

Which table displays MAC addresses that are learned on a switch?