ITS Modul 02 1-9

How is traffic routed between multiple VLANs on a multilayer switch?

Refer to the exhibit. In this network design, which connection or connections if any, add the VLAN ID number if host H1 sends information to host H2?

What is a characteristic of legacy inter-VLAN routing?

Refer to the exhibit. A network administrator needs to configure router-on-a-stick for the networks that are shown. How many subinterfaces will have to be created on the router if each VLAN that is shown is to be routed and each VLAN has its own subinterface?

Refer to the exhibit. In what switch mode should port G0/1 be assigned if Cisco best practices are being used?

Refer to the exhibit. What is the problem with this configuration, based on the output of the router?

Refer to the exhibit. Communication between the VLANs is not occurring. What could be the issue?

Refer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Users complain that PCs on different VLANs cannot communicate. Based on the output, what are two configuration errors on switch interface Gi1/1? (Choose two.)

Refer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Users complain that PC2 cannot communicate with PC1. Based on the output, what is the possible cause of the problem?

Refer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Based on the partial output that is displayed by the use of the show vlan command, which conclusion can be drawn for the Gi1/1 interface?

Inter-VLAN communication is not occurring in a particular building of a school. Which two commands could the network administrator use to verify that inter-VLAN communication was working properly between a router and a Layer 2 switch when the router-on-a-stick design method is implemented? (Choose two.)

How are IP addressing designs affected by VLAN implementations?

While configuring inter-VLAN routing on a multilayer switch, a network administrator issues the no switchport command on an interface that is connected to another switch. What is the purpose of this command?

What is a disadvantage of using multilayer switches for inter-VLAN routing?

An administrator is attempting to configure a static route on a Cisco 2960 series switch. After the administrator types the command ip route 0.0.0.0 0.0.0.0 10.1.1.1, an error message appears stating that the command is not recognized. What must the administrator do so that this command is accepted?

A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.)

What is a collapsed core in a network design?

Which two previously independent technologies should a network administrator attempt to combine after choosing to upgrade to a converged network infrastructure? (Choose two.)

What is a definition of a two-tier LAN network design?

A local law firm is redesigning the company network so that all 20 employees can be connected to a LAN and to the Internet. The law firm would prefer a low cost and easy solution for the project. What type of switch should be selected?

What are two advantages of modular switches over fixed-configuration switches? (Choose two.)

Refer to the exhibit. Consider that the main power has just been restored. PC3 issues a broadcast IPv4 DHCP request. To which port will SW1 forward this request?

What is one function of a Layer 2 switch?

Refer to the exhibit. How is a frame sent from PCA forwarded to PCC if the MAC address table on switch SW1 is empty?

What two criteria are used by a Cisco LAN switch to decide how to forward Ethernet frames? (Choose two.)

Which network device can be used to eliminate collisions on an Ethernet network?

Which type of address does a switch use to build the MAC address table?

What are two reasons a network administrator would segment a network with a Layer 2 switch? (Choose two.)

• to isolate ARP request messages from the rest of the network

Which statement describes the microsegmentation feature of a LAN switch?