Cartes mémoires RYR Online ATPL Tests

Cartes-fiches	178
Langue	English
Catégorie	Matières relative au métier
Niveau	Autres
Crée / Actualisé	13.07.2023 / 17.07.2023
Lien de web	https://card2brain.ch/box/20230713_ryr_online_atpl_tests
Intégrer	<iframe src="https://card2brain.ch/box/20230713_ryr_online_atpl_tests/embed" width="780" height="150" scrolling="no" frameborder="0"></iframe>

Which of the following statements best describes the construction of a battery?

Batteries are always in a metal casing to provide the negative connection point

Many batteries consist of more than one cell

A battery always consist of one cell

The two metal plates inside a battery cell are suspended in an air cavity

Batteries are always in a metal casing to provide the negative connection point

Many batteries consist of more than one cell

A battery always consist of one cell

The two metal plates inside a battery cell are suspended in an air cavity

Are you allowed to fly VFR above FL200?

No

Yes

Only in non-rvsm

Unless authorized by the appropriate ATS authority

No

Yes

Only in non-rvsm

Unless authorized by the appropriate ATS authority

Oxygen masks are required above which altitude?

10000ft

15000ft

25000ft

32000ft

10000ft

15000ft

25000ft

32000ft

What is Traffic Load?

Total mass of passengers, baggage and cargo, including any non-revenue load.

Mass of baggage and cargo

Mass of cargo only

Total mass of passengers, baggage and cargo, including any non-revenue load.

Mass of baggage and cargo

Mass of cargo only

Vy and Vx both:

Increase with an increase in altitude as true airspeeds.

Decrease with an increase in altitude as true airspeeds.

Remains the same

Increase with an increase in altitude as true airspeeds.

Decrease with an increase in altitude as true airspeeds.

Remains the same

Quick donning must be available above:

10000ft

15000ft

20000ft

25000ft

10000ft

15000ft

20000ft

25000ft

When does the intermediate part of the missed approach start?

At the beginning of the climb

At the threshold

2NM after runway

At the beginning of the climb

At the threshold

2NM after runway

VHF range is:

30 - 300 kHz

30 - 300 MHz

108 - 118 kHz

108 - 118 mHz

30 - 300 kHz

30 - 300 MHz

108 - 118 kHz

108 - 118 mHz

What is wind shear?

Sudden variation in wind direction

Intensity with temperature higher than surrounding.

Intensity with temperature lower than surrounding.

Sudden decrease in wind

Sudden variation in wind direction

Intensity with temperature higher than surrounding.

Intensity with temperature lower than surrounding.

Sudden decrease in wind

Glide slope interception angle?

3 degrees to 4 degrees

-5 degrees to 5 degrees

1.35 degrees to 5.25 degrees

5.25 degrees to 8.35 degrees

3 degrees to 4 degrees

-5 degrees to 5 degrees

1.35 degrees to 5.25 degrees

5.25 degrees to 8.35 degrees

If the ATC tells you ''STANDBY'' on a different frequency what do you do?

You will remain on the same frequency and in the other radio you will standby

X

You will remain on the same frequency and in the other radio you will standby

X

An AC is at 6000ft altitude and a DME station is at 1500ft the range?

153 NM

143 NM

83 NM

90 NM

153 NM

143 NM

83 NM

90 NM

DME congestion?

2 aircrafts

50 aircrafts

+100 aircrafts

+1000 aircrafts

2 aircrafts

50 aircrafts

+100 aircrafts

+1000 aircrafts

Which type of thunderstorm travels at the highest speed:

Frontal

Advection

Thermal

Frontal

Advection

Thermal

What is the purpose of bonding?

To ensure a zero volt electrical potential across the fuselage at all times

To ensure a uniform electrical potential throughout the fuselage by providing electrical connection between all parts

To discharge any build-up of static electricity to the surrounding atmosphere

To prevent the airframe from becoming statically charged when flying through areas of thunderstorm activity

To ensure a zero volt electrical potential across the fuselage at all times

To ensure a uniform electrical potential throughout the fuselage by providing electrical connection between all parts

To discharge any build-up of static electricity to the surrounding atmosphere

To prevent the airframe from becoming statically charged when flying through areas of thunderstorm activity

Leaving the ground effect at a given angle of attack the:

Induced drag decreases

Effective angle of attack(AOA) decreases

Lift will remain constant

Nose tend to pitch down

Keyboard commands:

= turn,

= for-/backward,

= scroll

Induced drag decreases

Effective angle of attack(AOA) decreases

Lift will remain constant

Nose tend to pitch down

Which of the following statements is true?

By increasing the flap setting in severe turbulence at constant speed the stall speed will be reduced and the risk for exceeding the structural limits will be decreased

Flap extension in severe turbulence at constant airspeed moves the centre of pressure aft, which increases the structural limitation margins

Flight in severe turbulence may lead to stall and/or structural limitations being exceeded

Flap extension in severe turbulence at constant speed increases both the stall speed and the structural limitation margins

Keyboard commands:

= turn,

= for-/backward,

= scroll

By increasing the flap setting in severe turbulence at constant speed the stall speed will be reduced and the risk for exceeding the structural limits will be decreased

Flap extension in severe turbulence at constant airspeed moves the centre of pressure aft, which increases the structural limitation margins

Flight in severe turbulence may lead to stall and/or structural limitations being exceeded

Flap extension in severe turbulence at constant speed increases both the stall speed and the structural limitation margins

What is the purpose of trim tabs?

To reduce control effectiveness

To reduce stick forces during manoeuvres

To increase control effectiveness

To reduce stick forces to zero

Keyboard commands:

= turn,

= for-/backward,

= scroll

To reduce control effectiveness

To reduce stick forces during manoeuvres

To increase control effectiveness

To reduce stick forces to zero

A turbo-supercharger impeller is driven by

Excess torque from the reduction gearbox

Diversion of exhaust gases by the waste gate using energy that would otherwise be wasted

A ram air turbine

A connection through a gearbox connected to the crankshaft

Keyboard commands:

= turn,

= for-/backward,

= scroll

Excess torque from the reduction gearbox

Diversion of exhaust gases by the waste gate using energy that would otherwise be wasted

A ram air turbine

A connection through a gearbox connected to the crankshaft

What is the effect on Mach No and TAS when climbing at a constant CAS?

Mach No increases, TAS is constant

Both increase

Mach No is constant, TAS increases

Both decrease

Keyboard commands:

= turn,

= for-/backward,

= scroll

Mach No increases, TAS is constant

Both increase

Mach No is constant, TAS increases

Both decrease

A hot busbar is one that

Is permanently connected to the battery

Supplies galley power

Carries all me non-essential loads

Is connected to the battery in an emergency

Keyboard commands:

= turn,

= for-/backward,

= scroll

Is permanently connected to the battery

Supplies galley power

Carries all me non-essential loads

Is connected to the battery in an emergency

The skin of modern pressurised aircraft

Is made up of light alloy steel sheets built on the monocoque principle

Houses the crew and payload

Is a primary load bearing structure carrying much of the loads

Provides aerodynamic lift and prevents corrosion by keeping out adverse weather

Keyboard commands:

= turn,

= for-/backward,

= scroll

Is made up of light alloy steel sheets built on the monocoque principle

Houses the crew and payload

Is a primary load bearing structure carrying much of the loads

Provides aerodynamic lift and prevents corrosion by keeping out adverse weather

Which of the following statements is true?

Super-alloys are used because of ther excellent corrosion resistance

Titanium alloy is used in aircraft construction because of its good wear and high temperature tolerance

Steel is used in aircraft because it is strong and heavy but has poor corrosion resistance

Aluminium alloys are used in aircraft construction because they are light, easily machined and have good wear resitance

Keyboard commands:

= turn,

= for-/backward,

= scroll

Super-alloys are used because of ther excellent corrosion resistance

Titanium alloy is used in aircraft construction because of its good wear and high temperature tolerance

Steel is used in aircraft because it is strong and heavy but has poor corrosion resistance

Aluminium alloys are used in aircraft construction because they are light, easily machined and have good wear resitance

The purpose of an ignition switch is to

Connect the battery to the magneto

Control the primary circuit of the magneto

Connect the contact breaker and condenser in series with the primary coil

Connect the secondary coil to the distributor

Keyboard commands:

= turn,

= for-/backward,

= scroll

Connect the battery to the magneto

Control the primary circuit of the magneto

Connect the contact breaker and condenser in series with the primary coil

Connect the secondary coil to the distributor

When selecting a fuse for an aircraft electrical circuit, the governing factor is:

The energy of the circuit

The power requirement of the circuit

The resistance of the circuit

The voltage of the circuit

Keyboard commands:

= turn,

= for-/backward,

= scroll

The energy of the circuit

The power requirement of the circuit

The resistance of the circuit

The voltage of the circuit

The ILS Localiser operates in the following frequency band:

108.0 - 112.0 kHz

108.0 - 112.0 MHz

328.6 - 335.4 MHz

328.6 - 335.4 kHz

108.0 - 112.0 kHz

108.0 - 112.0 MHz

328.6 - 335.4 MHz

328.6 - 335.4 kHz

What can be said about the height of the Tropopause in the Northern Hemisphere?

It increases from south to north

It decreases from south to north

It remains constant throughout the year

It remains constant from south to north

It increases from south to north

It decreases from south to north

It remains constant throughout the year

It remains constant from south to north

When an aircraft fitted with a classic air-driven artificial horizon decelerates after landing, a wrong indication will be displayed showing a:

Climbing turn to left

Descending turn to left

Climbing turn to right

Descending turn to right

Climbing turn to left

Descending turn to left

Climbing turn to right

Descending turn to right

What does TEM stand for in the context of Human Performance?

Threat and Error Managment

Trusted Equipment Mechanic

Time Limited Evacuation Medical

Tango, Echo, Mike

Threat and Error Managment

Trusted Equipment Mechanic

Time Limited Evacuation Medical

Tango, Echo, Mike

A pilot, trying to pick up a fallen object from the cockpit floor during a right turn, experiences:

Coriolis illusion/effect

Pressure vertigo

Autokinetic illusion

Barotrauma

Coriolis illusion/effect

Pressure vertigo

Autokinetic illusion

Barotrauma

RYR Online ATPL Tests

Créer ou copier des fichiers d'apprentissage

Créer ou copier des fichiers d'apprentissage

Connecte-toi pour voir toutes les cartes.

SWITCHaai

Office 365

Edulog

Apple ID

Google