USPA Category B Quiz

In flat and stable freefall at terminal velocity, how long does it take an average jumper to fall 1,000 feet?

What is the correct procedure for recovering from instability to the belly-to-earth position?

Which is better, to pull at the planned altitude or to fall lower to get stable before pulling?

What is the purpose of the wave-off before deployment?

What is the purpose of the parachute landing fall (PLF), and why is it important for skydivers?

What part of the landing pattern is most dangerous to skydivers?

How do higher wind speeds affect the planned landing pattern as compared to the pattern plan for a calm day?

In moderately strong winds, how far downwind of an obstacle would you expect to find turbulence?

What is the best procedure to use when flying your canopy in turbulent conditions?

What weather conditions and wind direction(s) are most likely to cause turbulence at your drop zone?

Why is it important to protect your parachute system operation handles when in and around the aircraft?

Describe the equipment pre-flight strategy to use before putting on your gear.

How does the three-ring main canopy release system disconnect the main parachute from the harness?

How do you know if a reserve parachute has been packed by an FAA rigger within the last 180 days?

How do you know the reserve container has not been opened since the FAA rigger last closed it?

If the surface winds are blowing from west to east, which direction will you face to fly the downwind leg of the landing pattern (instructor’s illustration)?

What is the wing loading of the parachute you will use on your next jump?

Which canopy size (same model design) will exhibit quicker control response?

a. 210-square feet with a 210-pound jumper (geared up)
b. 170 square feet with a 170-pound jumper (geared up)