ITS Modul 02 1-9

Consider the following routing table entry for R1:

D 10.1.1.0/24 [90/2170112] via 209.165.200.226, 00:00:05, Serial0/0/0

What is the significance of the Serial0/0/0?

Refer to the exhibit. A network administrator issues the show ipv6 route command on R1. What two conclusions can be drawn from the routing table? (Choose two.)

A network administrator configures the interface fa0/0 on the router R1 with the command ip address 172.16.1.254 255.255.255.0. However, when the administrator issues the command show ip route, the routing table does not show the directly connected network. What is the possible cause of the problem?

A network administrator configures a router by the command ip route 0.0.0.0 0.0.0.0 209.165.200.226. What is the purpose of this command?

What are two common types of static routes in routing tables? (Choose two)

What command will enable a router to begin sending messages that allow it to configure a link-local address without using an IPv6 DHCP server?

Which statement describes a route that has been learned dynamically?

Fill in the blank.
When a router receives a packet, it examines the destination address of the packet and looks in the ______________ table to determine the best path to use to forward the packet.

Refer to the exhibit. Match the description with the routing table entries. (Not all options are used.)

What is a disadvantage of using router-on-a-stick inter-VLAN routing?

How is traffic routed between multiple VLANs on a multilayer switch?

Refer to the exhibit. In this network design, which connection or connections if any, add the VLAN ID number if host H1 sends information to host H2?

What is a characteristic of legacy inter-VLAN routing?

Refer to the exhibit. A network administrator needs to configure router-on-a-stick for the networks that are shown. How many subinterfaces will have to be created on the router if each VLAN that is shown is to be routed and each VLAN has its own subinterface?

Refer to the exhibit. In what switch mode should port G0/1 be assigned if Cisco best practices are being used?

Refer to the exhibit. What is the problem with this configuration, based on the output of the router?

Refer to the exhibit. Communication between the VLANs is not occurring. What could be the issue?

Refer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Users complain that PCs on different VLANs cannot communicate. Based on the output, what are two configuration errors on switch interface Gi1/1? (Choose two.)

Refer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Users complain that PC2 cannot communicate with PC1. Based on the output, what is the possible cause of the problem?

Refer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Based on the partial output that is displayed by the use of the show vlan command, which conclusion can be drawn for the Gi1/1 interface?

Inter-VLAN communication is not occurring in a particular building of a school. Which two commands could the network administrator use to verify that inter-VLAN communication was working properly between a router and a Layer 2 switch when the router-on-a-stick design method is implemented? (Choose two.)

How are IP addressing designs affected by VLAN implementations?

While configuring inter-VLAN routing on a multilayer switch, a network administrator issues the no switchport command on an interface that is connected to another switch. What is the purpose of this command?

What is a disadvantage of using multilayer switches for inter-VLAN routing?

An administrator is attempting to configure a static route on a Cisco 2960 series switch. After the administrator types the command ip route 0.0.0.0 0.0.0.0 10.1.1.1, an error message appears stating that the command is not recognized. What must the administrator do so that this command is accepted?