Grundlagen CJ

how to

500

0.0 (0)

Fichier Détails

Cartes-fiches	500
Utilisateurs	42
Langue	English
Catégorie	Technique
Niveau	Autres
Crée / Actualisé	14.06.2019 / 12.09.2020
Lien de web	https://card2brain.ch/box/20190614_groundcourse_cj
Intégrer	<iframe src="https://card2brain.ch/box/20190614_groundcourse_cj/embed" width="780" height="150" scrolling="no" frameborder="0"></iframe>

Liste des carte

Étudier

The Engine SYNC switch ...

should be in the OFF position below 10000 ft

must be in the ON position for take-off and landing

must be in the OFF position for take-off and landing

should be the ON for single engine operation

To simulate a windshield overheat condition place the rotary TEST knob to W/S TEMP and set the

WINDSHIELD BLEED AIR knobs to OFF

WINDSHIELD BLEED AIR knobs to MAX

WINDSHIELD BLEED switch to HI or LOW

WINDSHIELD BLEED switch to OFF

Inflight starter assisted engine start is possible with ...

power from the running generator

power from the battery

There is more than one correct answer!

If the generators are not operating, the voltmeter reads battery voltage when the battery switch is in...

OFF

EMER

BATT

Mark the location of the pressurisation control panel

weiß ich doch eh

ich bin doof

The ailerons are operated by ...

hydraulic actuators

pneumatic pressure

wires

Where can the different TCAS modes be selected? (more than 1 correct)

On the upper radio tuning unit.

On the ATC control panel.

On the TCAS control panel.

On the lower radio control panel.

According to certification, the speedbrakes must be retracted prior to

50 feet GND

50 feet MSL

2000 feet GND

2000 feet MSL

There is more than one correct answer!

Mark the correct statements.

All pitot/static ports are electrically anti- iced

The pitot tubes are anti-iced by bleed air

All electrical heaters are switched in by a single switch

the angle of attack vane heater can be turned on individually

Only the static ports and the angle of attack vane are electrically anti-iced

Mark the correct statement.

A steady amber caution annunciator can be extinguished by pressing one of the two amber caution lights

A flashing amber caution annunciator indicates a malfunction that requires immediate action

A failure of both generators at the same time triggers the master warning

At a failure of one generator the master warning is activated

Is it possible to select two transmission channels on the audio selector panel simultaneously

Yes

The windshield rain removal system..

uses engine anti ice bleed air

is designed for high speed operation

uses windshield bleed air

uses service bleed air

Wing leading edge overheat is indicated by a...

steady WING ANTI-ICE annunciator light

flashing WING ANTI-ICE annunciator light

flashing WING ANTI-ICE annunciator light plus MASTER CAUTION lights

steady WING ANTI-ICE annunciator light plus MASTER CAUTION lights

According to certification, the speedbrakes must be retracted prior to...

50 feet GND.

50 feet MSL.

2000 feet GND.

2000 feet MSL.

Differential braking is not available ...

with anti skid INOP

if both engine driven hydraulic pumps fail

if the system loading valve is not energised

when using the emergency brake

Windshiel alcohol is provided for...

de-icing both windshields

anti-icing of both windshields

de-icing of the left windshield only

anti-icing of the left windshield only

With the throttles set to IDLE, the landing gear retracted and anti-ice switched OFF, the FADEC maintains approximately

70 %N2

57 %N2

46 %N2

23 %N2

What is the regulated output voltage of the generator

12 V DC

18 V DC

24 V DC

28 V DC

The outside check starts...

in front of the left engine, standing between the engine and the trailing edge.

in front of the right engine, standing between the engine and the trailing edge.

on the left side.

with the right engine from the front side of the right wing.

After take-off the gear is being retracted by moving the gear lever to the 'gear up' position. What effect does this action have on the landing lights?

After gear up the lights cut off automatically

All landing lights remain on, according to switch position

Ignition and boost pump operation during engine start are normally terminated...

by turning the IGNITION switch to OFF

automatically at approximately 45% N2

by turning the IGNITION and BOOST PUMP switches to OFF

by turning the BOOST PUMP switches to OFF

How many generators are installed on each engine of the CJ1+

During normal operation, the mode controlling cabin pressure is the...

Isobaric mode.

MANUAL mode.

AUTO mode.

During flight one engine fails.

An engine restart accomplished with the start button ...

is a generator assisted start

is a battery start

is prohibited

For normal braking...

electrical power must be available.

anti-skid must to be deactivated.

both engine-driven hydraulic pumps must be operating.

the system loading valve must be closed.

More than one:

A question concerning the air conditioning system.

Mark the air distribution settings which are typically used at nicht or in unusually cold air

weiß ich doch eh

ich bin doof

The speedbrakes retract automatically if ..

Grundlagen CJ

Créer ou copier des fichiers d'apprentissage

Créer ou copier des fichiers d'apprentissage

Connecte-toi pour voir toutes les cartes.

SWITCHaai

Office 365

Edulog

Apple ID

Google