Set of flashcards Grundlagen CJ (Page 2 of 13)

Flashcards	500
Students	42
Language	English
Category	Technology
Level	Other
Created / Updated	14.06.2019 / 12.09.2020
Weblink	https://card2brain.ch/box/20190614_groundcourse_cj
Embed	<iframe src="https://card2brain.ch/box/20190614_groundcourse_cj/embed" width="780" height="150" scrolling="no" frameborder="0"></iframe>

In flight, the engines return heated fuel to the tanks. This statement is...

false

true

What is the power supply of the standby flight display?

Standby battery

Emergency Battery

emergency DC power

normal DC power

If the generators are not operating, the voltmeter reads battery voltage when the battery switch is in... (There is more than one correct answer)

OFF

EMER

BATT

In case the cabin is overpressurized...

it can only be recognised on the cabin differential pressure gauge.

the cabin altitude exceeds 10000 feet

the CAB ALT warning horn sounds

the OVER PRESS annunciator light and the master caution light illuminate

The BLD AIR O'HEAT annunciator indicates an overheat condition...

at the wing root

in the horizontal stabilizer leading edge

downstream of the pylon precooler

in the engine nacelle leading edge

To simulate a windshield overheat condition place the the rotary TEST knob to W/S TEMP and set the...

WiNDSHIELD BLEED AIR knobs to OFF

WINDSHIELD BLEED switch to HI or LOW

WINDSHIELD BLEED AIR knobs to MAX

WINDSHIELD BLEED switch to OFF

Very hot engine compressor bleed air is extracted from the high pressure compressor and routed to...

the engine inlet and generator inlet anti-ice system

the cabin to pressurize the aeroplane

the de-ice boots

The ailerons are operated by...

pneumatic pressure

wires

hydraulic actuators

Analyse the following situation:

The aeroplane is on ground with both engines running.

The AIR CONDITIONING switch is moved to AUTO and the green COMPRESSOR ON light does not illuminate.

This indicates a system failure of the air conditioning system and requires further pilot action

This is normal if the cabin temperature is below the selected temperature

Mark all possibilities for starting the Williams FJ44-1AP engine...

(There is more than one correct answer!)

Battery start

APU assisted start

EPU assisted start

Crossfeed bleed air start

Regarding the engine fire-detection test, by placing the rotary TEST knob to FIRE WARN...

(There is more than one correct answer)

the left ENG FIRE light illuminate

the MASTER CAUTION lights illuminate

the MASTER WARNING lights illuminate

the right ENG FIRE light illuminates

What is the maximum cruising flight level of the CJ1+?

FL 390

FL410

FL430

FL450

Which system utilises hot engine bleed air extracted directly from the compressor.

Wing ice protection system

tail ice protection system

windshield ice protection system

engine ice protection system

The FRESH AIR position of the AIR SOURCE SELECT knob is used...

to provide fresh air to the windshield

anytime to increase the ventilation of the cabin

for ground use or low altitude unpressurized flights

Transmission via COM2 is selected on...

either of the two Radio tuning units (RTUs)

the Audio Control Panel (ACP)

the FMS

The normal fuel imbalance limit between the tanks is...

150 lb

100 lb

200 lb

250 lb

According to certification, the speedbrakes must be retracted prior to...

50 feet GND

50 feet MSL

2000 feet GND

2000 feet MSL

What is the total tank capacity of a CJ1+?

3420 lb

3620 lb

3220 lb

What is the precise indication of the gauges on the electrical panel?

The voltmeter indicates the generator or battery voltage. The ammeters indicate the load current of the generators and the battery.

The voltmeter indicates the battery voltage only. The ammeters indicate the load current of the generators and the battery.

The voltmeter indicates the generator or battery voltage. The ammeters indicate the load current of the related generators

The voltmeter indicates the battery voltage only. The ammeters indicate the load current of the battery.

The battery disconnect switch is used for...

(There is more than one correct answer)

stuck start relay.

stuck battery relay during battery overtemperature

test

Entering the cockpit for the cockpit safety inspection, the pilot is confronted with the depicted situation below.

Mark any switch which is in the wrong switch position.

Antwort wie bereits markiert.

The LH ENG FIRE light is illuminated.

Pressing the dark BOTTLE 1 ARMED PUSH button...

arms the electrical circuit for operation of the engine fire extinguisher bottle.

discharges halon from bottle 1 to the LH engine cowling

has no effect.

Which of the following aural warnings has a corresponding visual annunciator?

Voice: "Altitude"

Voice: "Landing Gear"

Voice: "Landing Light"

Voice: "Overspeed"

The engine fire extinguisher bottle pressure check is part of the exterior inspection.

This statement is...

true

false

The nosewheel steering is...

pneumatically actuated

hydraulically actuated

actuated through cables

mentally actuated

What is the regulated output voltage of the generator?

12 V DC

18 V DC

24 V DC

28 V DC

A good Battery supplies power to the hot battery bus and the emergency bus for approximately...

15 minutes

30 minutes

60 minutes

88 minutes

To verify that fuel transfer occurs from the left to the right tank, it is necessary to...

(There is more than one answer correct)

monitor the fuel quantity indicators for appropriate quantity changes

ensure, that both white FUEL BOOST ON annunciators illuminate

observe that the FUEL TRANSFER annunciator illuminates

ensure that the left FUEL BOOST ON light illuminates

ensure that the right FUEL BOOST ON light illuminates

Mark the correct statements.

(More than one answer correct)

All pitot/static ports are electrically anti-iced

the pitot tubes are anti-iced by bleed air

all electrical heaters are switched on by a single switch

the angle of attack vane heater can be turned on individually

only the static ports and the angle of attack vane are electrically anti-iced

The windshield rain removal system...

uses engine anti-ice bleed air

is designed for high speed operation

uses windshield bleed air

uses service bleed air

Windshield alcohol is provided for...

de-icing of both windshields

anti-icing of both windshields

de-icing of the left windshield only

anti-icing of the left windshield only

Ignition and boost pump operation during engine start are normally terminated...

by turning the IGNITION switch to OFF

automatically at approximately 45% N2

by turning the IGNITION and BOOST PUMP switches to OFF

by turning the BOOST PUMP switch to OFF

Which are the conditions that drop the passenger oxygen masks automatically?

Control Valve AUTO; Cabin ALT above 13500 ft; DC power available

Control valve NORMAL; Cabin ALT below 8000 ft, DC power available

Control valve NORMAL; Cabin ALT above 13500 ft; DC Power available

If one igniter fails during engine start...

the engine still starts normally

it results in a "hung start"

it results in a "hot start"

it results in a "wet start"

The hydraulic pumps are in operation when

a subsystem is activated

the engine is running

electrical power is switched on

the reservoir is pressurized with bleed air

The radar altimeter indicates...

an altitude

a flight level

a true altitude

a true height

a height

A red warning light illuminates on the annunciator panel, if...

the cabin altitude exceeds 10000 feet (+/- 500 feet)

the digital pressurization controller fails

the information form the ADC to the digital pressurisation controller is interrupted

Mark the correct statement concerning the emergency brake system.

It is allowed to taxi to the ramp with the emergency brake system in use

Multiple pulls of the emergency brake handle might result in brake loss

the brake pedals should be depressed during emergency braking

differential braking is possible.

What is the correct configuration for a sexond engine start on ground, if the first engine is running?

Both generator switches in OFF and the BATT switch in OFF

Both generator switches in GEN and the BATT switch in BATT

Both generator switches in GEN and the BATT switch in OFF

The primary source for windshield ice protection is...

bleed air

alcohol

electricity

Grundlagen CJ

Create or copy sets of flashcards

Create or copy sets of flashcards

Log in to see all the cards.

SWITCHaai

Office 365

Edulog

Apple ID

Google