Grundlagen CJ
how to
how to
Set of flashcards Details
Flashcards | 500 |
---|---|
Students | 42 |
Language | English |
Category | Technology |
Level | Other |
Created / Updated | 14.06.2019 / 12.09.2020 |
Weblink |
https://card2brain.ch/box/20190614_groundcourse_cj
|
Embed |
<iframe src="https://card2brain.ch/box/20190614_groundcourse_cj/embed" width="780" height="150" scrolling="no" frameborder="0"></iframe>
|
Transmission via COM2 is selected on...
The standby HSI is displayed automatically ...
The normal fuel imbalance limit between the tanks is ...
(...)lb
200
According to certification, the speedbrakes must be retracted prior to ...
More than one:
What are the pilot actions in case of an Elevator Trim Runaway
What is the total tank capacity of a CJ1+?
The flight mission is EDDW --> EDDG
EDDW ELEV 14´
EDDG ELEV 159´
AFTER START: Which altitude is entered by CM2 in the digital pressurisation controller? [feet]
400
When using the EPU, the...
Very hot engine compressor bleed air is extracted from the high pressure compressor and routed to ..
Is there any time limit for landing light operation on ground?
What is the correct configuration for a second engine start on ground, if the first engine is running?
The standby HSI is displayed automatically...
During windmilling operation, the maximum allowable operating oil consumption for the FJ44-1AP engine is...
In case the cabin is overpressurised,...
What is the precise indication of the gauges on the electrical panel?
What is the power supply of the standby flight display?
While waiting for the take-off clearance, the DOOR SEAL annunciator illuminates
Mark the correct statement concerning the brake system.
In case the cabin is overpressurised ....
Which system utilises hot engine bleed air extracted directly from the compressor?
There is more than one correct answer!
The battery disconnect switch is used for...
The minimum temperatur for a battery powered engine start is ..
-18 °C
What is the regulated output voltage of the generator?
The wings crossflow shutoff valve...
The standby HSI is displayed on the ...
A master warning can only be reset by...
On the ground, with either engine operating below approximately 90% N2...
The pilot wants to switch on the entry lights, but there is no green ENTRY light switch illumination. What are plausible reasons?
more than one answer!“
There is more than one correct answer!
The fasten-seat-belt signs come on when...
The standby HSI receives its heading data from
The Hydraulic pumps are in operation when ..
Mark all possibilities for starting the Williams FJ44-1AP engine... (more than 1 correct)
There is more than one correct answer!
Moving the flap selector lever to any position between 0° and 38°...
What happens if the electrical power to the hydraulic system loading valve is interrupted?
Inflight starter assisted engine start is possible with...