Performance
T1 erformance
T1 erformance
Which relation of V2 to VS (KVS-Factor) is the optimum for the obstacle limited t/o mass
Depends on the obstacle0s location
a) nearby obstacle: long t/o distance must be avoided and teh optimum KVS is low
b) distant obstacle: KVS is high and the climb speed can be as high as VXSE
What happen when anti skid system is inoperative?
What you must do?
1. ASD increases and PTOMF decreases
2. V1 must be reduced because of the reduced stopping performance, which leads to a longer TOD is there is an enginge failure
==> Reuction in V1, PTOMF and PTOMO
==> Flex T/O not allowed but derated T/O thrust may help due to the reduced VMCG
What dou you make by a contaimnated runway?
same as by a inop. anti skid system
=> PTOMF and PTOMObstacle hast to be reduced
PTOMF
Perfromance limitations for the field length
contaminated runway => V1?
V1 must be lower => In case of a reduction in V1 zhe VMCG limit has to be checked
==> climb limited take-off mass is not affected y RWY conditions
Until which contaminaation is a T/O allowed?
The contaminant's depth does not exceed 13 mm
=> the reduction of V1 is also limited by teh fact that OEI go case is subject to a higher rolling resistance caused by the contaminant
MALAM
Maximum allowable landing mass => lowest of:
a) approach climb and landing climb limited mass
b) landing feld length limited ladning mass
c) structural limited landing mass
TOGA Thrust available after?
after 8 sendons
Approach Climb is:
2.1% for 2-engin 2.4% for 3engin 2.7& for 4engin
Speed: 1.4 VSR
Gear retracted
Thrust: one engine failed => TOGA
Flaps: intermediae
Landing climb
Speed: 1.23 VSR0
Gear: extended
Thrust: all engines TOGA
Flaps: LDG
Gradient for all engines : 3.2%
Demonstrated landing Distance
actual distance from 50ft above RWY to a complete stop, based on the following conditions
- LDG conf
- VREF at 50 ft above RWY
- all ground spoiler are working
- no reverse thrust applied
==> Does not include any safety margin => best performance the aeroplane is capable of for the rpesent conditions
Landing distance required - Dry rwy
must not exceed:
1. 60% of the LDA for jet
2. 70% of teh LDA for turboprop
Landing distance require Wet RWY
at least 115% of teh requires landing distanve for a dry rwy ==> LDRwet jet= 1.15 * LDR dry
Dry rwy must not exceed:
1. 60% of the LDA for jet
2. 70% of teh LDA for turboprop
In which rage are the spoilers must effective?
In the upper speed range
What are not taken into account in the field length mim graph?
1. OAT
2. slope
3. hydroplaning => has no effect on teh field length limited landing mass
ACN
Aircraft Classification Number = the relativ eeffect of an aeroplane on a pavement for a specified standard subgrade
=> The most aft centre of gravity appropriate to teh max. ramp mass is used to calculate teh ACN
PCN
Pavement Classification Number = the bearing strength of a pavement is determined and reported by the appropriate authority
MQTM
Max. quick turnaround mass
max. brake temperature indication is reached approximately 5 minutes after the LDG is completed
==> If the landing mass exceeds the MQTM teh crew has to wait 53 minutes before T/O again
MALM => What is limiting?
MALM is either the performance limited landning mass or the structural landing mass(MLAM) whicheber is lower
min. obstacle clearance
2000ft descebding/ 1000 ft level
Was kommt es bei der Take Off Performance drauf an
Flugzeug, Umgebung, Piste und Pilot
slope
Neigung der Piste
VS1g
ninimum speed at which eh aeroplane develops a lift equal to the aeroplane weight => one g stall speed => The load factor is exactly one
VS
ninimum steady flight speed at which the aeroplane is controllable ==> zero thrust or idling ==> The load factor is always below one
Wie kommt na von VS1g auf VS
VS1g x 0.94 = VS
VS0
Stall speed or minimum steady flight speed in the landing configuration
VS1
Spar speed in a specified configuration => be safe under all reasonably expected conditions including turbulence and engine failure=> this speed until reaching the screen height => Mind. 20% higher than Stall speed
TORA
Take off run Available; Is the part of the airfield declared as suitable for performing take-offs by the aerodrome authorities
TORA is not necessarily the runway length. Because?
because of an intersection take-off
CWY
Clearway => Is limited to the half of the TORA => an area behind the ray, not less than 500ft wide
CWY => extending from teh end of teh rwy with an upward slope not exceeding xy % above which no object or terrain protrudes
1.25 %
TODA
Take Off Distance Available => TORA plus the length of the CWY
SWY
Stopway => Area beyond the take off ray => Support the aeroplane during an aborted take- off
to abort
abbrechen
ASDA
Accelerate stop Distance = TORA + SWY
LDA
landing distance Available => available and suitable for the ground run of a landing aeroplane
DRY Runway
runway surface is neither wet nor contaminated
Damp runway
runway surface is not dry, but when the moisture on it does not give a shiny appearance => Change in color due to moisture
Wet runways
runway surface is covered with water, but less than specified in subparagraph contaminated runway => appear reflective, but without significant areas of standing water
Contaminated Runway
more than 25% of the runway surface area ==>a) More than 3mm deep standing water b) snow compressed into solid mass c) ice, wet ice
-
- 1 / 276
-
Lernkarten
Was kommt es bei der Take Off Performance drauf an
Flugzeug, Umgebung, Piste und Pilot
slope
Neigung der Piste
VS1g
ninimum speed at which eh aeroplane develops a lift equal to the aeroplane weight => one g stall speed => The load factor is exactly one
VS
ninimum steady flight speed at which the aeroplane is controllable ==> zero thrust or idling ==> The load factor is always below one
Wie kommt na von VS1g auf VS
VS1g x 0.94 = VS
VS0
Stall speed or minimum steady flight speed in the landing configuration
VS1
Spar speed in a specified configuration => be safe under all reasonably expected conditions including turbulence and engine failure=> this speed until reaching the screen height => Mind. 20% higher than Stall speed
TORA
Take off run Available; Is the part of the airfield declared as suitable for performing take-offs by the aerodrome authorities
TORA is not necessarily the runway length. Because?
because of an intersection take-off
CWY
Clearway => Is limited to the half of the TORA => an area behind the ray, not less than 500ft wide
CWY => extending from teh end of teh rwy with an upward slope not exceeding xy % above which no object or terrain protrudes
1.25 %
TODA
Take Off Distance Available => TORA plus the length of the CWY
SWY
Stopway => Area beyond the take off ray => Support the aeroplane during an aborted take- off
to abort
abbrechen
ASDA
Accelerate stop Distance = TORA + SWY
LDA
landing distance Available => available and suitable for the ground run of a landing aeroplane
DRY Runway
runway surface is neither wet nor contaminated
Damp runway
runway surface is not dry, but when the moisture on it does not give a shiny appearance => Change in color due to moisture
Wet runways
runway surface is covered with water, but less than specified in subparagraph contaminated runway => appear reflective, but without significant areas of standing water
Contaminated Runway
more than 25% of the runway surface area ==>a) More than 3mm deep standing water b) snow compressed into solid mass c) ice, wet ice
4 Conditions for Rwy
1. Dry runway 2. Damp Rwy 3. Wet Rwy 4. Contaminated Runway
Screen Height
height is clear of obstacle and marks the end of the take-off distance ==> Min. 15m (50 ft) über Grund!!!!!
Take Ground Roll, Take off roll
distance between brake release and lift-off
TOD
Take off Distance: Distance between brake release and the point at which the aeroplane reaches the screen height
VR
Rotation Speed; pilot makes a control input with the intension of lifting
VLOF
Lift off speed => completely loses contact with the ground
Climb with falps =>
climb performance is reduced due to higher drag
Which speed must be reached at a height of 50 ft?
take off safety speed
Tailwind => wihich is the expected strength
150% of the normal strength (Geschwindigkeit) for take off
Headwind => wihich is the expected strength
50% of the normal strength (Geschwindigkeit) for take off
Wie kann man die Maximum Take off mass mit der Tabelle ausrechen
Man startet auf der rechen Seite => Distanz Rwy => Wind => Schnittpunkt => Wenn die Linie von rechts über der anderen Linie von rechts ist, ist die Piste zu kurz
VX
Best angle of climb ==> Geschwindigkeit für de steilsten Steigwinkel Ca. 4-5 its über stall ==> für DA 40 gibt es diese nicht
VY
Best rate of climb = >Geschwindigkeit für das Beste steigen
VCruise climb
Geschwindigkeit für den Reisesteigflug => Alle Hindernisse überflogen = Nase runternehmen und V Cruise
Range
Wie weit kann ich fliegen in NW
Endurance
wie lange kann ich fliegen
GPH
Gallons Per Hour
LR
Landing Roll, Ground Roll = Landerollstrecke => Distance between touch down and the point at which the airplane comes to a complete stop
LD
landing Distance: point at which the aeroplane has a height (50ft) above and the point at which the aeroplane come to a complete stop
VREF
Reference landing speed: point where the aeroplane desends through the landing screen
