CCNA3 FINAL EXAM

An administrator issues the router eigrp 100 command on a router. What is the number 100 used for?

A network administrator wants to verify the default delay values for the interfaces on an EIGRP-enabled router. Which command will display these values?

Which two parameters does EIGRP use by default to calculate the best path? (Choose two.)
 

Refer to the exhibit. Which two conclusions can be derived from the output?

(Choose two.)

When will a router that is running EIGRP put a destination network in the active state?

Which address is used by an IPv6 EIGRP router as the source for hello messages?

Refer to the exhibit. A network administrator issues the show ipv6 eigrp neighbors command. Which conclusion can be drawn based on the output?

Refer to the exhibit. Which route or routes will be advertised to the router ISP if autosummarization is enabled?

By default, how many equal cost routes to the same destination can be installed in the routing table of a Cisco router?
 

When a Cisco router is configured with fast-switching, how are packets distributed over equal-cost paths?

When should EIGRP automatic summarization be turned off?

Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol. R1 and R2 can ping the directly connected serial interface of their neighbor, but they cannot form an EIGRP neighbor adjacency.

What action should be taken to solve this problem?

Which two conditions should the network administrator verify before attempting to upgrade a Cisco IOS image using a TFTP server? (Choose two.)
 

Which requirement should be checked before a network administrator performs an IOS image upgrade on a router?

Refer to the exhibit. A network administrator is attempting to upgrade the IOS system image on a Cisco 2901 router. After the new image has been downloaded and copied to the TFTP server, what command should be issued on the router before the IOS system image is upgraded on the router?

What is the purpose of the Cisco PAK?
 

Which Cisco IOS Software Release 15.0 technology pack is shipped with a permanent license on all Cisco ISR G2 devices?

A network administrator issues the command R1(config)# license boot module c1900 technology-package securityk9 on a router. What is the effect of this command?

The ”  ________  ”  area interconnects with all other OSPF area types.

Refer to the exhibit. Match the description to the corresponding value used by the DUAL FSM. (Not all options are used.)

A network designer is considering whether to implement a switch block on the company network. What is the primary advantage of deploying a switch block?

Which characteristic would most influence a network design engineer to select a multilayer switch over a Layer 2 switch?

What are three access layer switch features that are considered when designing a network? (Choose three.)

In a large enterprise network, which two functions are performed by routers at the distribution layer? (Choose two.)

A set of switches is being connected in a LAN topology. Which STP bridge priority value will make it least likely for the switch to be selected as the root?

Refer to the exhibit. Which switch will be the root bridge after the election process is complete.

What are the possible port roles for ports A, B, C, and D in this RSTPWhat are the possible port roles for ports A, B, C, and D in this RSTP-enabled network-enabled network?

A network administrator enters the spanning-tree portfast bpduguard default command. What is the result of this command being issued on a Cisco switch?

Refer to the exhibit. A network administrator is configuring PVST+ for the three switches. What will be a result of entering these commands?

Refer to the exhibit. Which destination MAC address is used when frames are sent from the workstation to the default gateway?

A network administrator is analyzing the features that are supported by different first-hop router redundancy protocols. Which statement describes a feature that is associated with HSRP?
 

A network administrator is analyzing the features that are supported by different first-hop router redundancy protocols. Which statement is a feature that is associated with GLBP?

Which function is provided by EtherChannel?
 

Which mode configuration setting would allow formation of an EtherChannel link between switches SW1 and SW2 without sending negotiation traffic?

What are two requirements to be able to configure an EtherChannel between two switches?

(Choose two.)

Refer to the exhibit. Which two conclusions can be drawn from the output?

(Choose two.)

What two conditions have to be met in order to form a cluster that includes 5 access points?

(Choose two.)

A remote classroom can successfully access video-intensive streaming lectures via wired computers. However, when an 802.11n wireless access point is installed and used with 25 wireless laptops to access the same lectures, poor audio and video quality is experienced. Which wireless solution would improve the performance for the laptops?

Which wireless network topology is being configured by a technician who is installing a keyboard, a mouse, and headphones, each of which uses Bluetooth?