...
-
- 1 / 163
-
Flashcards
Pericardium
- Is the membrane enclosing the heart, the heart floats in fluid inside pericardium
- Prevents overstretching
- Reduces friction during contractions
The heart is an autonomous pump
- It generates its own beating and doesnt need nerves to beat
- However the heart beat rate is controlled by nerves (autonomic nerves system)
The heart is a pump. Pumps blood from body to lungs and back to body (circulation cycle). While passing through lungs, the blood acquires oxygen and gets rid of CO2 (which were used up and produced by body metabolism)
Basic electro --> chemical --> mechanical events in a heart cell (Drawing)
For a heart muscle cell to contract, a membrane potential is required. The ultimate contraction is Ca2+ concentration dependent. (voltage gated Ca2+ channels → calcium increase causes force)
blue controls green
green controla red
An isolated heart without calcium will stop beating, with calcium the beating will continue
Necessity of calcium for heart contraction
In muscle cells, there are actin and myosin fibres inside. Myosin paddles along actin in an ATP-dependent manner. This sliding of actin and myosin relative of each other = contraction.
Myosin can only bind to actin (and thus do contractions) when the calcium concentration is high.
The Ca2+ for the contractoin comes from the extracellular space and from sarcoplasmic reticulum
Excitation --> contraction coupling in a heart cell (Drawing)
- Depolarization of the muscle cell membrane (caused from neurotransmission) leads to opening of the \(Ca^{2+}\)voltage gated ion channels
- \(Ca^{2+}\)ions flow in (\(Ca^{2+}\)usually high outside and low inside the cell), \(Ca^{2+}\)binding to sarcoplasmatic reticulu also causes \(Ca^{2+}\) storage to flow out ⇒\(Ca^{2+}\)concentration gets even higher
- \(Ca^{2+}\)act on myosin / actin → contraction
How do heart cells generate the membrane potential waces, which make contraction happen?
Drawing: molecular biophysics of heart AP pacemaking
- Voltage gates Ion channels: activated in certain ranges of membrane voltage.
- Current through these channels changes membrane voltage
- So voltage-gated channels influence each others gating / opening by influencing voltage
This and different activation speeds of different channels (Na+ fast, K+ slow), produce self-sustaning cycling/oscillations in membrane voltage --> pacemaking
What does ECG (electrocardiogram) measure?
Because heart cells generate electrical waves roughly in sync with eachother, the combined waves of electricity are large enough to be recorded from the outside of patient's chest. This enables physicians to record ECG, from which they can look at rhythm abnormalities etc.
A graph of voltage versus time of the electrical activity of the heart using electrodes placed on the skin. These electrodes detect the small electrical changes that are a conseqeunce of cardiac muscle depolarization followed by repolarization during each cardiac cycle.
Special features of the heart muscle
- Heart cells are connected to each other mechanically and electrically (syncytium)
- This is an essential feature that enables the heart to work. Otherwise each cell would beat in isolation and there will be no overall contraction of the pump
Coupling between heart cells:
- Electrical = gap junction proteins
- Mechanical = desmosome proteins
Eletromechanical coupling between heart cells produces coordinated contraction of the whole heart. This is critical for blood pumping
Sino-atrial node
The heart cells that set/entrain the whole heart are located in the sino-atrial node (SAN- in right atrium wall)
SAN = natrual pacemaker of the heart
The rate is transferred through all cells via electrical connection
Heart valves
Heart valves ensure one way flow of blood. This is necesary for sending blood flow in the correct direction during contractions of atria and ventricles.
- Atrio-Ventricular Valces: prevent blood from flowing from ventricles to atria
- Semilunar valves: Prevent the return of blood to the heart
Innervation of heart
The heart beats autonomously (self-generated). The rate of this beat is modulated by autonomic motor nerves (ACh, NA)
Sympathetic nerve activity --> releases NA on heart --> accelerates heart rate
Parasympathetic nerve activity --> releases ACh on heart --> slows down heart rate
Regulation of heart pumping - Frankling Starling mechanism
FS mechanism: the more blood enters the heart, the stronger the heart contracts (intrinsic regulation of heart pumping)
Coronary vessels: heart arteries and veins
Coronary arteries supply heart with blood. Their clogging leads to heart attack (damage to heart muscles)
There are 2 key functions a heart has to deal with in order to work properly and supply the body with nutrients and oxygen: amount of workload (amount of blood) and contractility (ability to contract in the way it should). Therefor heart failure has to do with either one of those or both of these factors
Heart failure
= Output insufficient to provide enough O2 for tissue
Cardiac glycosides
- Classic heart-force-increasing agents
- Cardiac glycoside drugs increase force by increasing cytosolic Ca2+
- Cardiac glycoside drugs: Block Na/K pump. This makes more Calcium enter intracellular Ca2+ stores. So stronger contraction during electrical stimulation
How do cardiac glycosides increase cytosolic Ca2+?
- Block Na+ pump, so Na+ goes up
- Less Ca2+ leaves via Na+/Ca2+ exchanger
- More Ca2+ into SR
- More Ca2+ release!
ACE inhibitor drugs
Block blood vessel adaptations (constriction) that are normally caused by reduced cardiac output. This prevents failing heart from being destroyed further by its work load
It makes blood pressure decrease and therefore work load decrease, so that the failing heart can still pump without getting too stressed
Heart failure drug treatment: 2 main strategies
- Increase contractility: cardiac glycosided
- Reduced workload: ACE inhibitors
2 circulation systems in the body
- Pulmonary circle: heart to lungs to heart
- Systemic circle: heart to body to heart
Distribution of blood flow at rest and during strenuous exercise
Blood supply to brain stays constant across different behaviours
Structure of blood vessels: arteries vs. veins
In arteries, smooth muscle layer is thicker than in veins.
The wall structure variation in different vessels reflect their different funtions: Resistence to large pressure fluctuations (near heart arteries: a lot of collagen and elastin), and regulation of blood supply to organs and blood pressure (small arteries and arterioles: a lot of muscles)
Venous valves in legs
The venous valves ensure:
- that blood can only flow in one direction (back to the heart)
- that is flows, even though the blood pressure in veins is too low to bring the blood from the legs up to the heart
External pressure (like muscle contractions) compresses the veins and pushes the blood through
The elasticity of arteries
- Attenuates the pressure fluctuations caused by the heartbeat
- Converts the discontinuous heartbeat into continuous blood flow
Arterial blood pressure
The blood pressure in the aorta (and arteries) depends on the size of the heart stroke volume (like how much blood the heart pumps into the aorta during systole) and the total peripheral resistance (like the resistance of the peripheral vessels)
Why does blood pressure increase with age?
- Because the elasticity of the blood vessels decreases.
- Because of limitations / changes in renal function (reduced excretion of sodium)
Interpreting changes in arterial pressure pulse: increase in systolic pressure
Indicates increase heart stroke volume (--> systolic = when heart contracts)
Interpreting changes in arterial pressure pulse: Increase in diastolic pressure
Indicates increase in peripheral resistance (--> diastolic = when heart relaxes)
In capillaries happens the exchange of:
- Gases
- Nutrients
- Hormones
- Electrolytes
- Metabolytes
This exchange is mostly passive --> driven by osmotic and hydrostatic pressure
Endothelium (internal) : Structure of blood vessel walls
- Is an epithelial cell layer
- Determines and controls capillary permeability
Substances can pass between or across endotheliak cells. The path taken depends on size and water permeability of the substance.
- Small, lipid-permeable: through cells
- Small, water-permeable: between cells or theough cells via transporters
- Large: between cells
- Very large (albumin): get stuck and cant cross
Muscle (middle): structure of blood vessel walls
- Determines vessel diameter
- Circulatory regulation involves control of muscle tone in vessels (mainly arterial). This involves neural, endocrine, and paracrine mechanisms. As vessel size decreases, control gradually switches from mostly central neural (vasoactive Autonomic motor nerves) to mostly local chemical (hormones, gases, tissue osmolarity)
Neural control of blood pressure
Reduced blood pressure stimulates pressure receptors to activate the sympathetic outflow and thus increases heart activity and vessel constriction.
Hormonal control of blood pressure: RAA loop
feedback control
1. Low blood pressure
2. Sensed by kidney → release of renin hormone
3. Renin catalyses precursor hormone of liver called Angiotensinogen to Angiotensinogen I
4. Angiotensinogen I is substrate for another enzyme called ACE (from lungs) → converted to Angiotensinogen II
5. Angiotensinogen II acts on vessels and brain → increase in blood pressure