777 Memory Items
Test
Test
Kartei Details
Karten | 7 |
---|---|
Sprache | Deutsch |
Kategorie | Physik |
Stufe | Andere |
Erstellt / Aktualisiert | 28.03.2017 / 30.12.2023 |
Lizenzierung | Keine Angabe |
Weblink |
https://card2brain.ch/box/20170328_777_memori
|
Einbinden |
<iframe src="https://card2brain.ch/box/20170328_777_memori/embed" width="780" height="150" scrolling="no" frameborder="0"></iframe>
|
Cabin Alt
- Don the oxygen mask. Don the oxygen mask.
- Establish crew communications. Establish crew communications.
- Check the cabin altitude and rate. Check the cabin altitude and rate.
- If the cabin altitude is uncontrollable:
“EMERGENCY DESCENT”
- Push the PASS OXYGEN switch to ON and hold for 1 second.
Without delay , descend to the lowest safe altitude or 10,000 feet, whichever is higher.
To descend:
• Set altitude on MCP(1)
• Select heading on MCP(1)
• Engage FLCH(1)
• Move the thrust levers to idle
• Extend the speedbrakes
• SPEED on MCP to VMO/MMO
structural integrity? limit airspeed
PA: “EMERGENCY DESCENT"
Komische Geschwindigkeit
“AIRSPEED UNRELIABLE MEMORY ITEMS”
“AUTOPILOT DISENGAGE SWITCH PUSH”
Pushes the autopilot disengage switch
“BOTH A/T ARM SWITCHES OFF”,
- puts his hand to the A/T arm switches.
“OFF”
- Selects the A/T arm switches to OFF.
“BOTH F/D SWITCHES OFF”,
- puts his hands to the FD switches.
“OFF”
- Selects the FD switches to OFF.
Sets the following gear up pitch attitude and thrust:
- Flaps extended 10 degrees and 85% N1
- or
- Flaps up 4 degrees and 70% N1
- Monitors correct attitude and thrust, calls out deviations.
“AIRSPEED UNRELIABLE MEMORY ITEMS COMPLETE”
Engine Damage
“ENGINE SEVERE DAMAGE/SEPARATION Right MEMORY ITEMS”
“L/R A/T ARM SWITCH – CONFIRM – OFF”,
- puts his hand to the left or right A/T arm switch.
“OFF”
- Selects the left or right A/T arm switch to OFF.
“L/R THRUST LEVER – CONFIRM – IDLE”,
- puts his hand to the left or right thrust lever.
“IDLE”
- Retards the thrust lever to idle.
“L/R FUEL CONTROL SWITCH – CONFIRM – CUTOFF”,
- puts his hand to the left or right fuel control switch.
“CUTOFF”
- Selects the left or right fuel control switch to cutoff.
“L/R ENGINE FIRE SWITCH – CONFIRM – PULL”,
- puts his hand to the left or right engine fire switch.
“PULL”
- Pulls the left or right engine fire switch.
“ENGINE SEVERE DAMAGE/SEPARATION L/R MEMORY ITEMS COMPLETE”
Right Engine Fire
“FIRE ENGINE L/R MEMORY ITEMS”
“L/R A/T ARM SWITCH – CONFIRM – OFF”
- puts his hand to the left or right A/T arm switch.
“OFF”
- Selects the left or right A/T arm switch to OFF.
“L/R THRUST LEVER – CONFIRM – IDLE”,
- puts his hand to the left or right thrust lever.
“IDLE”
- Retards the thrust lever to idle.
“L/R FUEL CONTROL SWITCH – CONFIRM – CUTOFF”,
- puts his hand to the left or right fuel control switch.
“CUTOFF”
- Selects the left or right fuel control switch to cutoff.
“L/R ENGINE FIRE SWITCH – CONFIRM – PULL”,
- puts his hand to the left or right engine fire switch.
“PULL”
- Pulls the left or right engine fire switch.
- If the FIRE ENG message stays shown:
“L/R ENGINE FIRE SWITCH ROTATE”,
- puts his hand to the left or right engine fire switch.
“ROTATE”
- Rotate the left or right engine fire switch to the stop and hold for 1 second.
- Start timing (by pushing clock switch or opening NNC).
- If after 30 seconds, the FIRE ENG message stays shown:
“L/R ENGINE FIRE SWITCH ROTATE TO THE OTHER STOP”,
- puts his hand to the left or right engine fire switch.
“ROTATE”
- Rotate the left or right engine fire switch to the other stop and hold for 1 second.
“FIRE ENGINE L/R MEMORY ITEMS COMPLETE”
Engine Stall
“ENGINE LIM/SURGE/STALL L/R MEMORY ITEMS”
“L/R A/T ARM SWITCH – CONFIRM – OFF”,
puts his hand to the left or right A/T arm switch.
“OFF”
- Selects the left or right A/T arm switch to OFF.
“L/R THRUST LEVER – CONFIRM – RETARD”,
- puts his hand to the left or right thrust lever.
“RETARD”
- Retards the thrust lever until engine indications stay within limits or the thrust lever is at idle.
“ENGINE LIM/SURGE/STALL L/R MEMORY ITEMS COMPLETE”
Stabilizer
“STABILIZER MEMORY ITEMS”
“BOTH STAB CUTOUT SWITCHES CUTOUT”,
- puts his hand to the center and right stabilizer cutout switches.
“CUTOUT”
- Selects the center and right stabilizer cutout switches to cutout.
“DO NOT EXCEED THE CURRENT AIRSPEED”
Maintains maximum current airspeed.
“STABILIZER MEMORY ITEMS COMPLETE”
2 x Eng out
“DUAL ENGINE FAIL/STALL MEMORY ITEMS”
“BOTH FUEL CONTROL SWITCHES CUTOFF THEN RUN”,
- puts his hands to the left and right fuel control switches.
“CUTOFF THEN RUN”
- Selects the left and right fuel control switches to cutoff and then to run.
“RAM AIR TURBINE SWITCH PUSH”,
puts his hand to the ram air turbine switch.
“PUSH”
- Pushes the ram air turbine switch and holds for 1 second.
“DUAL ENGINE FAIL/STALL MEMORY ITEMS COMPLETE”